Photo Frame
Equipment:
- Round file
- Flat file
- Piece of plastic - 90mm x 300mm
- Sand paper P180
- Strip heater
- Disc sander
- Drill press
- 25mm forstner bit
Steps:
- Mark on the piece of plastic 50mm in from the left side.
- Mark on the piece of plastic 200mm in from the left side.
- Mark on the piece of plastic 5mm from the top side and the bottom side.
- Rule a line from the 5mm mark to the 50mm mark like shown in the picture.
- Sand the plastic to the line using the disc sander.
- Use a file to file all around the piece of plastic.
- Sand using a sanding paper after filling.
- Mark the middle of the last square.
- Use a 25mm forstner bit on a drill press to drill a semi-circle using the mark as a guideline.
- Place the 50mm marked line on the strip heater and leave it there for 2-3 minutes.
- Take it off and bend it to 10°.
- Place the 200mm marked line on the strip heater and leave it there for 2-3 minutes.
- Take it off and bend it all the way back.